Tommy Jenkins' Chassis

This shows the IFS for the 1932 Pinch Nose.  Ride height on this front end is set with the bottom A-Arms parallel to the ground.  Notice how nicely the center cross member matches up with the fire wall and floor.  

Did you want your car low?  Check this out.  All of our chassis are built to the customers specifications.  Tommy Jenkins requested that this chassis be set up with 24" tires up front.

This is a picture of the Halibrand Quick Change.  The body is sitting on top the rear cross member, so it is 2" off the frame rails in the rear.  If you want the car low you have to modify the rear trunk.  There were no shocks in this picture. Ride height was established and the pictures taken at "ride height."  To view additional pictures go to page 6.

A picture says a thousand words, but the quality in our chassis does not show up on these pictures.  Imagine this body 2" lower in the rear, when it is sitting correctly on the frame rails.

Call or e-mail 1-888-875-6666

Page 6

Frequently Asked Questions

Home

Remember here at Hotrodheaven and Hot Rods USA we say:  "Run Your Own Race"® 

Front page to Hot Rods USA

Copyright reserved by Dean Oshiro.  Reproduction without written approval is a violation of Copyright Laws.  Sept 2000