Pictures on this page are curtisey of Chris Malcolm.

These pictures show the kick up in the rear.  Make special note of the 4 bar location and mounting.  It is so low in the back the upper bars extend above the frame rails.  So the body has to be channeled over the 4 bars.  We prefer to use the "wish bone" locator to keep everything straight in back and would have rather used our tri-angluated vs parallel 4 link.

To the left we have the Wilwood Dual Master Cylinder set-up.  The bracket in front of the master cylinders is for the clutch set-up.  Picture below shows the hair pin mount position almost at the top of the frame rails.  Check out any other 33/34 and see where this is located.  

Picture lower left shows the wheel well location at pre-ride height.